CAUTION:
KNIFE BLADE IS VERY SHARP!
Parts List
- Blade
- White
Teflon washers (2)
- Left
liner
- Left
bolster
- (8)
Short round head screws
- Pivot
pin screw (uses T8 torx driver)
- (2)
Flat head screws
- (2)
Standoffs
- Blade
stop pin
- Pivot
pin
- Right
bolster
- Right
liner
Note:
With the exception of the pivot pin screw (1), all screws use a size T6
torx driver. Pivot pin screw uses size
T8 driver.
-
Insert
blade stop pin (9) into hole in the right liner (12) as shown in diagram.
- Rotate
pivot pin (10) so flat area aligns with flat spot in right bolster/liner hole,
and insert as shown
- Place
white teflon washer (2) over pin
(10) on inside of right liner. Then
fix blade (1) on to pivot pin in
open
position.
- Note: The
back end of blade should rest against
stop pin (11).
- Place white
Teflon washer (2) over end of pin (10).
- Align holes
in left liner (3) over end of pin (10).
- Align
standoffs (8) over holes between liners.
- Insert
flathead screws (7) and thread-in lightly.
- Close
blade
and check alignment. Adjust by slightly
flexing liners. If necessary, tighten
screws firmly.
- Attach
handle scales of your choice or those provided in the upgrade kit with
remaining short screws.
- Using
two short round head screws (5) attach
left bolster (4) to left liner (3). Repeat
procedure for right bolster (11)
and
right liner (12).
If you have questions or need additional help, please see our running FAQ and discussion forum for more instructions and modification advice.
|
