These are Corby Bolts. They are used for knife handle fasteners. With this design, you will create a step hole in your handle material that is slightly larger than the shank of the fastener. The two-part assembly allows for you to pass the shank precisely through your knife tang hole and handle material, allowing the larger radius of the Corby Bolt heads to create a pinch point on both sides of the handle material, where it can then be tightened down to a secure hold. Once the bolt has been tightened, it can be sanded to a flush finish with the handle surface. This will result in a smooth, pin-like visual effect on the final knife handle. When used with epoxy and/or thread-locker adhesive, they will create a permanent handle bond. Specifications Head Diameter = .312 in. (ea.) Head Length = .320 in. (ea.) Shank Diameter = .250 in. Shank Length = .315 in. Overall Length (min) = (0.960 in) Overall Length (max) = (1.15 in) Thread = US 8-32 Driver = Slot Material = Brass Sold As: (1) Corby Bolt Set = (1) Threaded Male + (1) Threaded Female
Dymalux™ - Handle Scale Set - Layered - Green Mountain Camo - (5 x 1.5 x .3)
$12.95
Dymalux™ - Handle Scale Set - Layered - Mickey D - (5 x 1.5 x .3)
Dymalux™ - Handle Scale Set - Layered - Alliance - (5 x 1.5 x .3)
Dymalux™ - Handle Scale Set - Layered - Supreme Camo - (5 x 1.5 x .3)
*Ranger Classic Knife Kit - Hidden Tang Design - Blade Blank
$24.95
Stack Handle Spacer - Wenge - (1.5 x 0.25) - (1 Pack)
$1.95
Finishing Washers - #8 - Countersunk - Nylon - Olive Drab
$0.35
KYDEX® Sheet - Kryptek Xtreme™ - Olive Drab - Micro - Infused - (.080)
$16.95
Photo Gallery #1 Photo Gallery #2 -------------- Knife Terminology General Knife Safety Basic Knife History Kit Instructions Knowledge Base
Sales/Support +1.877.255.6433
Password Forgotten