This knife handle bushing is used to reduce the through-hole diameter on a knife handle tang. Using this model (BUSHING4), you would reduce a 1/4 inch (.250") tang hole down to a .140" hole. This reduction will allow a smaller diameter pin or fastener diameter to pass through cleanly, but will virtually eliminate side-to-side movement. Using a bushing reducer like this will provide you with far more artistic control over your final handle fastener diameter and will ensure that the resulting mechanical handle construction is safe and tight. These can also be used with handle epoxies to permanently affix the handle. In addition to use as a through-hole reducer, these knife handle bushings are very popular as folding knife standoffs (spacers), and can be used in many other applications, such as lanyard findings. Specifications BUSHING4 Diameter (OD) = .250 in. Diameter (ID) = .140 in. Length = .116 in. Material = Brass Sold Individually
Knife Pivot Washers - Phosphorous-Bronze - (.300x.200x.022) - (For 5mm Pivots)
$0.70
Knife Pivot Washers - Phosphorous-Bronze - (.330x.197x.005) - (For 3/16 Pivot)
Knife Pivot Washers - Phosphorous-Bronze - (.330x.197x.015) - (For 3/16 Pivot)
$0.99
Knife Pivot Washers - Phosphorous-Bronze - (.330x.197x.020) - (For 3/16 Pivot)
Knife Pivot Washers - Phosphorous-Bronze - (.500x.197x.020) - (For 3/16 Pivot)
$0.79
Knife Pivot Washers - Phosphorous-Bronze - (.333x.157x.020) - (For 5/32 Pivot)
Knife Pivot Washers - Nylon - (.315x.156x.020)
$0.40
Knife Pivot Washers - Nylon - (.315x.156x.012)
Photo Gallery #1 Photo Gallery #2 -------------- Knife Terminology General Knife Safety Basic Knife History Kit Instructions Knowledge Base
Sales/Support +1.877.255.6433
Password Forgotten