Our #8 Journeyman Series Rivet/Eyelet flaring die set is designed to "roll" the unflared side of a 1/4" inch sheath rivet (eyelet) by using a small hammer, in conjunction with our Journeyman Series die guide (sold separately). These dies are sold as a two part set (male/female). They are milled from high quality stainless steel. All CKK rivet flaring dies have been heat-treated for long life. They have also been tumble polished to insure the correct smoothness needed for a professional rivet/eyelet finish. No other flaring dies in the industry work better than ours! CKK Dies are the industry standard, used by professionals who make thousands of sheaths.
#8 rivets require a .250 inch hole (1/4) drilled in the thermoplastic KYDEX® sheet or leather for fastening.
#8 Die = Designed for 1/4 Kydex Rivet (eyelet)
Heat treated (for maximum wear resistance)
Note: Sold die set (male/female) only. Does not require tabletop guide for use, but is "highly" recommended for precision flaring performance. Images below are for examples only.